Rear Brake Lining Control - Beta Motorcycles R12 Bedienungsanleitung

4

REaR BRaKE liNiNG CONTROl

2mm
In order to verify the wear condition of rear
brake is enough to view the caliper from
above, where is possible to glimpse the
brake lining tails which will have to show
a brake of 2 mm in thickness. If the stratum
is lesser let's start replacing them.
Note:
Perform the check according to the times
shown in the table on page 48.
To replace, contact authorised Betamotor
customer service.
GB
41