3
2
2
GB
1
1
3
28
BRaKES
REaR BRaKE
The rear brake is disk type with hydraulic
control.
You may adjust pedal height by means of
register 1.
Once you change the original pedal po-
sition you need to modify regulator 2 on
the brake pump to allow you to reset the
correct pump travel.
WARNING: reduced play causes
brake overheating leading to sudden
lockup.
adjuSTmENT Of GaS
ClEaRaNCE
The throttle control cable should always
have a 3-5 mm play. In addition, the idle
speed should not change when the han-
dlebars are fully rotated to the left or right.
To adjust the clearance proceed as follows:
- Push upwards the rubber cap 1.
- Rotate register 2 with respect to sheath 3.
- Push the rubber cap towards the carburettor
when correct backlash is achieved.