Starting The Engine; Cold Starting; Engine Shut-Down; Speed Limitation Device - Beta Motorcycles R12 Bedienungsanleitung

2

STaRTiNG ThE ENGiNE

Move the fuel tank valve in ON position (see page 20).
Check that the button is inserted correctly in the tear-off stop device (page 21).
KICKSTART (page 23):
depress the kick-starter with a sharp movement of the foot.
ATTENTION
Once the pedal has been depressed, release it immediately. This avoids jolts to the
entire ignition group and to the foot.

COLD STARTING:

operate the starter (page 21), start the vehicle, wait a few seconds, then move
the starter back to its starting position.

ENGiNE ShuT-dOwN

To shut-down the engine:
Remove the button from the tear-off stop device (page 21).
NOTE:
With the engine off, make sure the fuel cock is set to OFF (page 20).

SpEEd limiTaTiON dEviCE

This vehicle is equipped with a speed limiter. Use this device until the user feels
comfortable with the vehicle.
Contact the Betamotor assistance service to remove it.
GB
26