Chapter 6 Machine Adjustment And Setting Up; Control Panel - Minipack-Torre Pratika 56CS Installations-, Gebrauchs- Und Wartungsanleitung

Chapter 6. Machine adjustment and setting up

6.1. Control panel

The machine is fitted with a control panel, mounted on support, from which all programming and operation functions can
be set.
1 Led "alarm". Flashes if one of the machine sensors shuts down the operating process.
2 Led "long heater". Lights up when heater is powered.
3 Led "short heater". Lights up when heater is powered.
4 Display. Displays selected functions and relative settings.
5 Led "sealing". Illuminates to indicate machine sealing process.
6 Led "rear film". Lights up when rear film position is on.
7 Led "front film". Lights up when front film position is on.
9 Button "AUTOMATIC – MANUAL". Selects machine operation mode.
10 Button "DECREASE". Reduces set function values.
11 Button "INCREASE". Increases set function values.
12 Button "SELECT". Selects functions set in the various programs.
13 Button "START". Starts the operating process.
14 Button "STOP". Stops the operating process.
15 Button "DRIVE". Start the "film drive" function (in manual).
16 Button "SEAL – RESET". Start the film sealing function (in manual). With the automatic programm it resets the
cycles counter.
Q1 Main switch. Turns the machine on and off.
S0 Pushbutton "EMERGENCY". Shuts down the machine immediately in the event of immediate danger or when
the machine is set to maintenance mode. Rotate clockwise to release.
S1 Button "RESET". Press when starting up the machine.
Restores the machine after the intervention of the "EMERGENCY" button.
S2 "BYPASS SAFETY PROTECTIONS" selector. If this selector switch is set to OFF, the machine may only be
operated if the panels are closed (AUTOMATIC program). If this selector switch is set to ON, the machine may
be operated with the panels open. This condition is necessary "only" when carrying out the set-up procedures
and when inserting or changing the film reel (MANUAL program only).
E1 GREEN light element. Flashes (intermittent green light) when the machine is ready for use.
On (continuous green light) when the machine is running.
E2 RED light element. Illuminated whenever an alarm is activated, together with an acoustic signal.
29
GB