Chapter 2. Film Features; Films To Be Used; Band A Calculation; Chapter 3. Machine Usage Conditions - Minipack-Torre Pratika 56CS Installations-, Gebrauchs- Und Wartungsanleitung

Chapter 2. Film features

2.1. Films to be used

The machine can work with all heat shrink and non-heat shrink films, from 15 to
50 microns in thickness, of a technical and food type.
To guarantee the best results, it is recommended to use the films marketed by
us.
The special features of our films assure their outstanding reliability, with regard
both to compliance with laws in force and to an excellent machine performance.
Consult the data and safety sheets of the films in use and
observe the corresponding instructions!

2.2. Band A calculation

Band A = b + c + 100mm
By band "A" we mean the width that the film must have to package the product.

Chapter 3. Machine usage conditions

3.1. Max. pack sizes

a = 600mm b = 400mm
N.B.: measurements shown refer to the maximum for the single dimension.
Refer to chapter 2.2. to get max. dimension of pack (b x c); the addition of (b + c)
is equal to film roll width minus 100mm.

3.2. Items that may be packaged

These machines are capable of packing a wide range of completely different products. They are used successfully in the
following sectors: food, marketing, graphics and mailing, large distribution, industry, fabrics.

3.3. Items which must not be packed

The products listed below must absolutely not be wrapped to avoid permanent damage to the machine and serious
injuries to the operator:

Wet and unstable products

Liquids of any kind and density in fragile containers

Flammable and explosive materials

Pressurised gas cylinder of any kind

Loose and volatile powders

Any materials and products not listed but which might harm operator and damage the machine.
c = 240mm
25
A = mm700 MAX
D = mm300 MAX
GB
GB