Charging; Connecting To Power Supply - Stihl MSA 120 C Gebrauchsanleitung

4 Safety Precautions
► Apply the spiked bumper properly.
► Always cut with the chain running at full speed.
4.8.3 Pushback
The saw is pushed back toward the operator when the top of
the bar is used for cutting.
WARNING
￭ If the rotating chain makes contact with a hard object and
is suddenly pinched, the saw can be abruptly pushed back
toward the operator. The operator can lose control of the
saw and be seriously or fatally injured.
► Hold the saw firmly with both hands.
► Operate the saw as described in this instruction manual.
► Keep the guide bar straight in the cut.
► Always cut with the chain running at full speed.
0458-716-9621-C
4.9

Charging

WARNING
￭ A damaged or defective charger may produce an unusual
smell or emit smoke during the charging process. This
may result in personal injuries and damage to property.
► Disconnect the plug from the wall outlet.
￭ The charger can overheat and cause a fire if heat
dissipation is inadequate. This can result in serious or
fatal injuries and damage to property.
► Do not cover the charger.

4.10 Connecting to Power Supply

Contact with live components may occur for the following
reasons:
– The connecting cable or extension cable is damaged.
– Connecting cable plug or extension cable is damaged.
– Wall outlet is not properly installed.
DANGER
￭ Contact with live components can result in an electric
shock. This can result in serious or fatal injuries.
► Check that the connecting cable, extension cable and
their plugs are not damaged.
If the connecting cable or extension cable is
damaged:
► Do not touch damaged areas.
► Disconnect the plug from the wall outlet.
► Never touch the connecting cable, extension cable or
their plugs with wet hands.
► Insert the appliance plug of the connecting cable or
extension cable in a properly installed fused wall outlet
with ground contact.
► Install the charger with a ground fault circuit interrupter
(30 mA, 30 ms).
English
65