Troubleshooting; Troubleshooting Chainsaw Or Battery - Stihl MSA 120 C Gebrauchsanleitung

English

19 Troubleshooting

19.1 Troubleshooting Chainsaw or Battery

Condition LEDs on Battery
Saw does not start 1 LED flashes
when switched on. green.
1 LED glows red. Battery too hot or too cold. ► Engage the chain brake and remove the battery.
3 LEDs flash red. Malfunction in saw.
3 LEDs glow red. Chainsaw is too hot.
4 LEDs flash red. There is a malfunction in
Saw cuts out during 3 LEDs glow red. Chainsaw is too hot.
operation
86
Cause
Battery has low charge.
the battery.
No electrical contact
between the chainsaw and
battery.
Saw or battery damp
There is a electrical
malfunction.
Remedy
► Charge the battery.
► Allow battery to cool down / warm up.
► Engage the chain brake and remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
► Disengage the chain brake.
► Switch on the saw.
► If 3 LEDs continue to flash red: Do not use your
chainsaw and contact your STIHL servicing dealer
for assistance.
► Engage the chain brake and remove the battery.
► Allow chainsaw to cool down.
► Engage the chain brake, remove and refit the
battery.
► Disengage the chain brake.
► Switch on the saw.
► If 4 LEDs continue to flash red: Do not use the
battery and contact your STIHL dealer for
assistance.
► Remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
► Allow saw or battery to dry
► Engage the chain brake and remove the battery.
► Allow chainsaw to cool down.
► Remove battery and insert it again.
► Switch on the saw.
19 Troubleshooting
0458-716-9621-C