Example: Direct Controlling Of The Display Segments To Display "Hello" On The Can Display; Example: Display The Values Of A Bus Member - Kübler Codix 538 Bedienungsanleitung

0x1600sub6
0x6410 Show 8-bit integer value
0x6410sub0
0x6410sub1
0x6410sub2 Show value UINT8
Object
0x6411 Show 16-bit integer value
0x6411sub0
0x6411sub1
0x6411sub2 Show value UINT16
0x6412 Show 32-bit integer value
0x6412sub0
0x6412sub1
0x6412sub2 Show value UINT32
0x6413
0x6413sub0
0x6413sub1
15 Example: Direct controlling of
the display segments to display
"HELLO" on the CAN display
This example only operates when the display is in
Operational mode.
Control the display starting from the right side (with
O). To display the letter "O", the segments A, B, C,
D, E and F (see 6.6 on page 5) must be lit:
www.kuebler.com
6.Mapped Object
Number of entries
Show value INT8
Name
Number of entries
Show value INT16
Number of entries
Show value INT32
Show value float
Number of entries
Show value float
var ui32 rw
var ui8 const
var i8 rww
var ui8 rww
ObjT. DataT. AccT.
var ui16 const
var i16 rww
var ui16 rww
var ui8 const
var i32 rww
var ui32 rww
var ui8 const
var real32 rww
Digit1 "O" =222 = 0xde
Digit2 "L" = 208 = 0xd0
Digit3 "L" = 208 = 0xd0
Digit4 "E" = 248 = 0xf8
Digit5 "H" = 118 = 0x76
Digit6 " " = 0 = 0x0
The value 222 for the letter "O" is obtained from:
A(8)+B(4)+C(2)+D(128) + E(64)+F(16) =222
(see 6.7, page 5)
16 Example: Display the values of a
bus member
Application programming (PDO display on COB-ID
0x1a3 with the 32 bits UINT data format)
Before setting the CAN display, a ResetNode must
be carried out. Then Object 1400 must be set to
"invalid".
Now, the CAN display may be programmed.
0x0 no
0x2 no
0 yes
0x0 yes
Default Mapping
0x2 no
0 yes
0x0 yes
0x2 no
0 yes
0x0 yes
0x2 no
0 yes
Page 9