Removing The Belt In The Event Of Unit Failure - RADEMACHER RolloTron Comfort 9600 Betriebs- Und Montageanleitung

i

22. Removing the belt in the event of unit failure

In the event that the roller shutter belt winder unit fails and
the motor no longer runs, you can use the disengaging
bracket provided in order to fully remove the belt from the
belt winder unit, without the need for cutting it.
1.
Remove the mains plug from the socket or switch off
the mains power supply.
2.
Dismantle the roller shutter belt winder as previously
demonstrated on page 104.
3.
Release the drive with the help of the supplied disen-
gaging bracket.
ATTENTION
◆ Hold on to the belt tightly, as otherwise the roller shut-
ters may slam shut.
◆ A small amount of resistance must be overcome when
pressing.
4.
Maintain pressure on the disengaging bracket and pull
the belt out of the roller shutter belt winder as far as
possible.
5.
Release the belt from the fastening hook and pull it out
completely from the roller shutter belt winder.
6.
Replace the disengaging bracket in its holder.
106
Comfort
Drive
device
release
Device for
large belt
boxes
Drive
release
Storage bay
EN