Mounting The Roller Shutter Belt Winder - RADEMACHER RolloTron Comfort 9600 Betriebs- Und Montageanleitung

i

12. Mounting the roller shutter belt winder

Mount the roller shutter belt winder as straight as possible,
so that the belt can wind correctly.
Ensure that the roller shutter belt winder sits freely in the
belt box and that it isn't in contact with the masonry, oth-
erwise noise will be generated during operation.
1.
Slide the roller shutter belt winder into the belt box and
screw it tight using the screws provided.
IMPORTANT
If you use a cable with an mains plug.
Ensure that the connecting cable is laid correctly inside
the cable duct, otherwise it can be crushed and damaged
when the cover is screwed in place.
2.
Slide the enclosed cover plate over the lower mount-
ing holes.
3.
Operating
◆ Switch the mains power back on or re-insert the mains
plug into the 230 V / 50 Hz socket. This completes the
installation process.
92
Comfort device
EN
Device for large belt boxes