i
16. End point adjustment
IMPORTANT
The end points must be configured in order that the roller shutters stop at the desired upper and lower positions. It is imperative that
both end points are configured, otherwise malfunctions may occur.
Set the upper end point
1.
Press and hold the Set key.
2.
Press the [ Up ]-key once.
The roller shutter moves upwards.
3.
Release the Set key, ...
...as soon as the roller shutter achieves the
desired position for the upper end point.
The roller shutter stops and the upper end
point is stored.
96
I 2 : 0 0
AUTO
▲
▼
NOTE
Tighten the belt slightly, until it is ten-
sioned by the weight of the roller shutters.
IMPORTANT
Do not set the upper end point
right up to the limit stop. Release
the key promptly and never
allow it to extend beyond the
respective end point. Failure to
do so can cause overloading and
may damage the roller shutters
and / or drive.
NOTE
The set button is slightly
recessed in the front panel.
Please use a thin pen or similar
tool in order to press the set
button.
Example:
Comfort device
EN