Drawing In And Fastening The Belt - RADEMACHER RolloTron Comfort 9600 Betriebs- Und Montageanleitung

i

11. Drawing in and fastening the belt

1.
Plug the mains plug into the socket or switch on the
mains power.
2.
Briefly press the [ Clock ] key until the display
[ 12:00 ] appears.
3.
Press the [ Up ] key until the fastening hooks
is easily accessible in the reel compartment.
There is a risk of injury from the reel.
STOP
◆ Never reach into the reel compartment when the
motor is running.
4.
Always switch the mains power off again before feeding
the belt into the top of the roller shutter belt winder.
◆ Continue to feed the belt into the device and subse-
quently slide the belt over the fastening hooks from
above.
5.
Switch the mains power back on again.
/ Briefly press the [ Clock ] key and then
◆
the [ Up ] key until the belt has wound
completely once around the reel.
◆ Pull the belt tight when winding, so that the deflection
roller turns at the same time.
Insert belt into the top.
Belt path inside the roller shutter belt winder
Fastening hook
6.
Finally remove the mains plug from the socket again
before replacing the reel compartment cover back onto
the reel compartment.
EN
Belt
91