Description Of The Configurable Parameters - RADEMACHER 3500 08 64 Betriebsanleitung

i
8. Description of the configurable parameters
EN
The most important configurable parameters are described here for
carrying out the basic configuration (installation) of the actuator.
Running time:
This sets the time which the drive requires for a complete lift of the
shutters. In order to record the time, please move the shutters down
to the lower limit position and then move them to the upper limit
position. Record the time as precisely as possible during the lifting
process. Add 1 to 2 seconds to the measured duration in order to
allow for deviations in the running time caused by temperature
changes. Configuration of the running time is required to enable
targeted movement to a specified position (e.g. using the HomePilot).
The more precisely the time is recorded, the more accurately the
desired intermediate position (e.g. sun position) will be assumed.
Blinds mode:
If this mode is active, the automatic slat tilting functions are avail-
able. This mode should be deactivated for use with roller shutters
and awnings.
Standard slat position ***
This parameter sets the position in which the slats are to be turned
after automatic tilting (0% = open (tilted in the „up" position),
100% = closed (tilted in the „down" position).
Automatic tilt after manual stop direction „Down":
If this parameter is activated, the slats will be automatically tilted to
the „down" position after manually stopping and will be shifted to
the default slat position.
35