i
15. Commissioning the roller shutter belt winder
1.
Switch the mains power on or insert the mains plug into
the 230 V / 50 Hz socket.
1.1
Continue with point 2 if the following display appears.
:
–
– –
AUTO
▲ ▼
This display appears on initial installation as well as after a
long power failure.
1.2
Should a random time be displayed after turning on
the mains power, you can immediately start with the
settings on page 96.
I 3 : 0 5
AUTO
▲ ▼
2.
Briefly press the [ Clock ] key until the
following display appears.
I 2 : 0 0
AUTO
▲ ▼
3.
Continue with "end point adjustment", see page 96.
EN
95