i
21. Removing the roller shutter belt winder (e.g. in the event of a move)
1.
Fully close the roller shutters.
2.
Erase all settings.
Press and hold the keys
for e.g. 8 seconds, s. page (27).
3.
Briefly press the [ Clock ] key until the
display [ 12:00 ] appears.
4.
Keep the key held down.
4.1
In doing so, pull out the belt as far as possible from the
top of the roller shutter belt winder.
5.
Remove the cover plates from the mounting holes.
6.
Subsequently release the fastening screws and pull
the roller shutter belt winder completely out of the
belt box.
7.
Remove the belt compartment cover.
There is a risk of injury from the reel.
STOP
◆ Never reach into the reel compartment when the
motor is running. Always remove the mains plug or
switch off the mains power before touching the reel
compartment.
104
Comfort device
EN
Device for large belt boxes