Safety Devices; Transport; Installation; Installation Place - Nussbaum TTC 500 Betriebsanleitung

(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
The TTC 500 tyre changer has a number of safety devices designed to guarantee the
utmost operator safety:
1) Double seal piloted check valve (see Fig. A).
This prevents the spindle carrier vertical carriage from dropping suddenly if the
hydraulic circuit accidentally breaks.
2) Pressure relief valve set at 90 bar (located inside the control console).
This limits the maximum pressure in the hydraulic circuit and thus ensures good
functional performance for the entire system.
3) Motor overload cut-outs (see Fig. B).
These trip if the motors overheat and prevent them from burning out.
CAUTION: Removing or tampering with the safety devices
is in violation of European safety regulations and releases
the manufacturer from all liability for damage caused by
or related to such actions.
The machine is delivered in a wooden box with pallet.
Shipping weight is 465 kg.
The machine must be handled with a fork-lift truck with the forks positioned as
shown in the figure C.
Choose the place the machine is to be installed in compliance with current work place safety regulations.
The floor should not be broken or uneven so that the machine will be stable.
If the installation is outdoors, it must be protected by some kind of roofing against rain.
The following work environment conditions are applicable:
Relative humidity: from 30-95% without condensation;
Temperature: from 0-55° C.

4. SAFETY DEVICES

5. TRANSPORT

6. INSTALLATION

6.1 INSTALLATION PLACE

25
A
B
C
TTC 500