Safety Notices; Safety Notices For The Operating Staff - Nussbaum BM 10-2 Bedienungsanleitung

2.

Safety notices

Please note the listed safety instructions are for your own
safety and for the safety of your customers. The safety
instructions will explain to you the possible dangers. At
the same time, they contain notices on how you can
prevent dangers from occurring by using the equipment
properly.
Please see also Installation instructions 1 689 978 478N.
The safety instructions are also contained in the opera-
ting instructions. They are characterized by the following
symbols:
i Information - contains a notice
! Caution - points out dangers for the test device/
sample
Danger for persons - designated generally
2.1

Safety notices for the operating staff

i Please read and understand the accident preventi-
on regulations!
i When the wheel balancer is not used, switch off the
power supply via the main switch. Secure the main
switch against unauthorized use.
i Do not leave any wheels on the wheel balancer for
a prolonged period of time.
i Working with the electrical system may only be exe-
cuted by trained electricians.
! The wheel guard should always be closed during
the balancing process.
When switching on the wheel balancer,
wheels and other objects must not be
mounted on the main shaft.
When operating the wheel balancer with an
open cover, other people should not be wi-
thin the machine range!
Danger of life can exist for people around
the wheel area.
Repairs or other works must not be execut-
ed on the wheel balancer if the machine
has not been set to the de-energized state
(unplugged from mains).
40
The operational display of the wheel balan-
cer is shown on the monitor. In order to en-
sure that the operating state (On/Off) can
be detected at any time; one must ensure
under all circumstances that the monitor is
visible at all times.
The operating staff must wear working clo-
thes without loose strips and loops. This also
includes the work shoes without shoe laces.
Loose strips and shoe laces could get into
the wheel balancer and could endanger
the operator.
The wheel must be mounted to the wheel
balancer with the corresponding clamping
means.
The wheel balancer must be unplugged
from the main electricity supply before
maintenance work is executed.
Danger of electric shocks!
The electric system must be protected
against humidity and moisture.
Danger of electric shocks!
Do not carry out any set-up work while the
inspection is being executed.
Danger of injuries!
27.10.2011 1 689 979 917N