Correct Operation Checks; Operation; Clamping The Wheel - Nussbaum TTC 500 Betriebsanleitung

(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
WARNING:
Unreadable and missing warning labels must be replaced immediately.
Do not use the tyre changer if one or more labels are missing.
Do not add any object that could prevent the operator from seeing the labels.
Use the code in this table to order labels you need.
Before using the tyre changer, a number of checks should be make to ensure
its complete functional performance.
1) After installation according to the instructions given in Chapter 6, start up the
machine by turning the main switch to position "1" (2, Fig. H).
2) Move the top lever (1, Fig. H) to the right: the horizontal carriage must move
to the right.
Move the lever to the left: the horizontal carriage must move to the left.
DANGER!
There can be danger of limb crushing when the horizontal
carriage is moving.
ALWAYS operate the machine keeping well out of the carriage's working range.
3) Move the side lever (3, Fig. H) up; the vertical carriage must rise.
Move the lever down; the vertical carriage must lower.
DANGER!
There can be danger of limb crushing when the vertical carriage is moving.
ALWAYS operate the machine keeping well out of the carriage's working range.
4) Move the bottom lever (4, Fig. H) up: the spindle must turn clockwise.
Move the lever down and the spindle must turn counter-clockwise.
NB: For greater operator safety, all the controls are of the "dead-man" type; that is, they will automatically return to the neutral
position when released.
NB: the TTC 500 tyre changer can clamp wheels with rim from 14.5" to 24.5".
Clamping is through the centre hole using accessories CF1 and CF2 included in the standard supply. It is also possible to clamp rims
without centre holes by using optional accessory AUC.
CLAMPING THROUGH THE CENTRE HOLE
1) On the basis of rim diameter, select the most suitable type of spindle to clamp the wheel:
CF1 for wheels with rim diameter from 14.5" to 17.5".
CF2 for wheels with rim diameter from 19.5" to 24.5".

10. CORRECT OPERATION CHECKS

11. OPERATION

11.1 CLAMPING THE WHEEL

2
29
1
3
4 H
TTC 500