Assembly - Cleanmaxx 07675 Gebrauchsanleitung

EN

Assembly

PLEASE NOTE!
■ Before you attach or detach any accessories, ensure that the device is not connected
to the mains power.
Inserting / Removing the Hose
• Inserting: Plug the connection piece (7) into the suction intake opening on the device.
When you do this, make sure that the two locking lugs sit in the recesses which are
provided for them. Twist the connection piece (7) clockwise unti it locks in place.
• Removing: Twist the connection piece (7) anticlockwise and pull it off.
Inserting / Removing the Telescopic Tube
Adjusting the Length of the Telescopic Tube
Attaching / Removing Suction Nozzles
• Attaching: Plug the free end of the telescopic tube (3) as far as it will go into the noz-
zle you want. Twist the nozzle back and forth slightly as you do this.
• For greater fl exibility, the nozzles can also be plugged directly onto the suction
hose (9).
• Removing: Simply pull off the nozzle you have used.
Inserting / Removing the Dust Container
• Removing: Press the release button (10) of the dust container (8) and pull it out of the
device by the carrying handle.
• Inserting: Grip the dust container (8) by the carrying handle and fi rst place the bottom
of the container into the device. Then press the carrying handle against the device
housing until the dust container (8) audibly engages in the locking catch. Lift up the
device by the carrying handle to check whether the dust container (8) is in the correct
position.
• Inserting: Plug the open end of the handle (1) into the matching
opening of the telescopic tube (3). Twist the handle (1) back and
forth slightly as you do this. Then check that it fi ts securely.
• Removing: Simply pull the telescopic tube (3) away from the han-
dle (1).
• Push the slider on the telescopic tube (3) downwards and pull the
telescopic tube (3) out to the length you want.
• Release the slider and move the telescopic tube (3) a little bit
more until it engages.
22