Walking Foot - Bernette Moscow 2 Bedienungsanleitung

E55-E82e_EN_DE_TR_EL_310309:07_55-90e_EN_ES_FR_PT.qxd
65
31.3.2009 14:36 Seite 118
80e 90e
GB EN

Walking foot

Presser foot available as optional accessorie
Always try to sew first without the
walking foot accessory which should be
used only when necessary.
The "Walking foot" accessory equalizes the
feeding of the upper and lower layers of
fabric and improves the matching of plaids,
stripes and patterns. This foot helps to
prevent uneven feeding of very difficult
fabrics.
1. Lift the presser foot bar.
2. Remove the "presser foot holder" (see
page 32)
3. Attach the "walking foot" to the
machine in the following way.
i) The fork arm should fit into the
needle screw and clamp. (2)
ii) Slide the plastic "attaching head"
from your left to right so that it is fitted
on the "presser foot bar".
iii) Lower the "presser foot bar".
iv) Tighten the fixation screw
4. Make sure both the "needle screw"
and the "fixation screw" are tight.
5. Draw the bobbin thread up. Lay both
threads to the back under the foot
a Fork arm
b Attaching head
c Needle bar
d Needle screw & clamp
e Presser bar attaching screw
f Presser foot bar