Monogramming And Embroidering With Embroidery Hoop - Bernette Moscow 2 Bedienungsanleitung

E55-E82e_EN_DE_TR_EL_310309:07_55-90e_EN_ES_FR_PT.qxd 31.3.2009 14:36 Seite 108
EN GB
Embroidery hoop available as optional
accessorie
· Set the machine as illustrated.
· Pattern selector on " "
· Remove the presser foot and the presser
foot holder.
· Move the drop feed control to right side
to lower the feed dogs. (1)
· Lower presser foot lever before starting to
sew.
· Turn the stitch length dial to "0".
· Adjust the stitch width according to the
size of lettering or design.
Preparation for Monogramming and
Embroidering
· Draw the desired lettering or design on
the right side of the fabric.
· Stretch the fabric between embroidery
hoop as firmly as possible.
· Place the fabric under the needle. Make
sure the presser foot bar is down in its
lowest position.
· Turn the balance wheel towards you to
bring up the lower thread through the
fabric. Sew a few securing stitches at the
starting point.
· Hold the hoop with both hands and
guide it.
Move drop feed control to the left side for
normal use.
Please note:
No "S" marking is shown on the stitch
length dial by model
Monogramming and embroi-
dering with embroidery hoop
/ .