Viking MF 860 Gebrauchsanweisung Seite 24

EN
ENGLISH
pulley, and that the cables do not become entan-
gled with the steering pinions.
Do not tension the steering cables too hard. Other-
wise the steering will be heavy and wear and tear
on the cables will increase.
STEERING CHAINS (MF 890 PRO)
The steering chains should be adjusted for the first
time after the machine has been in operation for 2
- 3 hours, and then after every 50 hours of opera-
tion.
Put the machine in the straight-ahead position.
Tension the steering chains by tightening up the
nuts that are located on the underside of the articu-
lated steering joint (fig. 16). Tension until all play
is removed.
Adjust both the nuts the same amount to ensure
that the alignment of the steering wheel is not
changed.
Do not over-tighten the steering chains. This will
cause the steering to become heavy and will in-
crease wear on the steering chains.
24