Menu Control; Main Menu; Parameter Setting For The Interfaces; Offset - SICK DME3000-2 RS 422 Gebrauchsanweisung

DME 3000-2 _ _
Software 1.1

4 Menu control

For the Menu overview see Page 40.

4.1 Main menu

The main menu offers the following options:
INTERFACE
SERVICE
RETURN

4.2 Parameter setting for the INTERFACES

The INTERFACE submenu offers the following options:

OFFSET

OUT1
OUT2
SERIAL
RS 422
SSI CODE
AVERAGE
RESPONSE TIME
MODE
4.2.1 OFFSET
Additional setting for the measuring result display, the RS 422 serial interface and the switching
outputs Q1 and Q2. The defined threshold refers to the displayed value.
Range: - 500 000 mm ... + 500 000 mm
Function: Display = serial interface = measuring value + offset
Switching outputs:

4.2.2 OUT1 / OUT2

Menu title for configuring the switching outputs Q1 and Q2.
Default:

4.2.2.1 LIMIT 1 / 2

Switching point setting in mm steps, LIMIT 1 and LIMIT 2 can be set independently of each other.
Range: - 016 383 mm ... + 032 766 mm

4.2.2.2 HYST 1 / 2

Setting for the switching hysteresis in steps of 2 mm (symmetrically around the switching point). If the
measuring range is exceeded when LIMIT and HYST are combined, the respective end value of the
measuring range is used as the hysteresis threshold value.
Range: 0 ... 254 mm

4.2.2.3 NORM 1 / 2

Inversion of the switching outputs (HIGH / LOW idle state):
Q: LOW if measuring value < switching limit
Q : HIGH if measuring value < switching limit
Parameter setting for the interfaces
Commissioning aids, error displays
Return to current measurement reading display / Power On display
OFFSET
Switching output Q1
Switching output Q2
Selection of serial interface
Parameter setting for the serial interface
Parameter setting for the synchronous serial interface
Progressive average calculation
Response time
Measuring range selection
LOW = measuring value + offset + 0.5 x hysteresis < limit
HIGH = measuring value - offset - 0.5 x hysteresis > limit
LIMIT 1 / 2:
HYST 1 / 2:
NORM 1 / 2:
1000
2
Q1, Q2
Page 27