Reely Core XXL Bedienungsanleitung Seite 79

Steering works opposite to the way the turning wheel is turned at the transmitter
• Activate the steering reverse setting at the transmitter using the slider "ST.REV". Then you may need to correct the
trim for steering using the trim controller "ST.TRIM".
Driving works opposite to the movement of the throttle/brake lever at the transmitter
• Usually, the vehicle should drive forwards if you pull the throttle/brake lever at the transmitter towards the handle.
If this is not the case, activate the reverse setting for the driving function at the transmitter using the slider "TH.REV".
• If the motor has been disconnected from the speed controller, swap two of the three motor cables. This will reverse
the rotational direction of the brushless motor.
The vehicle does not reverse
• Between switching from forward to reverse driving, the throttle/brake lever at the transmitter must be in the neutral
position briefly. If you move the throttle/brake lever from forward to reverse without a break, the brake will be acti-
vated; the vehicle will not reverse!
• Reversing has been deactivated in the speed controller's programming; see chapter 11. b).
The driving time is very short
• Charge the drive battery or use a different, fully charged drive battery.
79