Commissioning; Outdoor Sensor; B) Weather Station - Conrad 672861 Bedienungsanleitung

9. Commissioning

a) Outdoor Sensor

The DCF receiver is integrated in the temperature/humidity sensor housing. This leads to much less
interference in DCF reception than in other weather stations.
Observe:
If you have not installed the holder assembled in chapter 8 with the sensors in the outdoor area yet, but
they are still within a building, there may be reception problems (DCF time is not displayed on the weather
station).
We recommend that you first install the holder and sensors outdoors and then insert the included batteries
into the battery compartment of the temperature/humidity sensor.
• Open the battery compartment at the temperature/humidity sensor by pushing the battery compartment lid downwards.
• Insert the two included batteries into the battery compartment in the correct polarity (observe plus/+ and minus/-)
and closed the battery compartment again. A red LED in the housing lights up for about 4 seconds and then goes out
again. When the DCF signal was recognised, the LED flashes 5 times and then goes out.
• The DCF receiver in the temperature/humidity sensor now scans for the DCF signal. This may take about 5 minutes.
Do not move the holder with the sensors during this time.

b) Weather Station


Please note:
The DCF receiver integrated in the housing of the temperature/humidity sensor requires about 5 minutes
at good reception until it has completely received and assessed the data in the DCF signal.
If you insert batteries in the weather station during this time, the weather station may display measured
values for temperature, humidity, wind direction and wind speed after a while, but not DCF time and date
yet.
Just wait for a few minutes until the DCF time and date are sent in addition to the measured values; the
DCF time and date display appears automatically on the weather station then (bottom-most display line).
• Open the battery compartment lid on the rear of the weather station and insert 3 type AA/mignon batteries into with
correct polarity (observe plus/+ and minus/-).
• All display segments appear briefly on the weather station's display after the batteries are inserted. Then the weather
station issues a signal sound.
• Close the battery compartment again.
• The weather station is now scanning for the outdoor sensor's transmitter signal. Between the display of the indoor
and outdoor humidity, the symbol „
Do not touch the weather station touch screen during this time and do not move the weather station.
• After a few minutes, the outdoor temperature/humidity should be displayed, as well as the wind speed, wind direction
and rain volume.
" for transmitter display is displayed.
63