Reset Function - Conrad 12 79 49 Bedienungsanleitung

"RUN" Run (activate in computer language)
"PAUSE" Momentary stopping of the measurement
"°C" Degrees Celsius; unit of measurement during temperature
measurements using the optional temperature adapter
"°F" Degrees Fahrenheit; alternative unit of measurement during
temperature measurements using the optional temperature
adapter
"%RH" Unit of measurement for relative humidity using the optional
RH adapter)
"Psi" Unit of measurement for pressure using the optional adapter
"Hi - A" Unit of measurement for high currents during current measu-
rement via an optional clamp adapter
"SAVE" Storage of a measured value or the screen content
"CALL" Recall of a stored measured value or the screen content
"TEST" Self-test of the measuring instrument; during this, the internal
computer is checked
This lightning symbol indicates the range has been exceeded
during current or voltage measurement
All remaining symbols indicate the various units of measurement:
AC = AC value
DC = DC value
mV = millivolt (V exp.-3)
V = volt (unit of electrical potential difference)
A = ampere (unit of electrical current)
Hz = hertz
kHz = kilohertz (hertz exp.3)
kΩ = kilohm (ohm exp.3)
10
MΩ = megohm (ohm exp.6)
pF = picofarad (farad exp. -12)
nF = nanofarad (farad exp.-9)
µF = µF = microfarad (farad exp.-6)
mF = millifarad (farad exp.-3)
4.4 Buttons configuration and functional
description of buttons
4.4.1 General
All parameters can be changed/set by means of the various buttons on
the instrument. Buttons F1 to F4 are designated as so-called software
buttons, with which settings are possible directly in the screen menu.

4.4.2 Reset function

When the "Auto Power Off" function ("SLEEP", selectable under
"INSTALL") has switched the measuring instrument off after some 30
minutes of inactivity (to save energy), the unit can be switched on again
by pressing any of the 8 buttons.
4.4.3 MODE (HZ)
Two display modes are possible with the GDM: multimeter display and
oscilloscope (graphical) mode.
Switching from one display mode to the other is done with the "MODE"
button. The graphical display is however possible only with the follo-
wing functions:
• AC current and voltage measurement
• DC current and voltage measurement
• mV / Hi-Z function ("Hi-Z" = high impedance, i.e. the input resistance is
"extremely" high)
11