Adjustment Of The Swash Plate Position - Reely SKY Lama 6 Bedienungsanleitung


11.

Adjustment of the Swash Plate Position

The swash plate (1) is controlled via two micro servos.
The front servo at the left side of the model in flight direction
(2) controls the rolling function and the rear one on the right
model side (3) controls the nod function.
When the control lever and the trim control for the roll and
nod functions are in their centre positions, the two servo
levers (4) must be aligned horizontally and must not be tilted.
If the servo lever is badly misadjusted, the holding screw
can be loosened and the lever can be reattached adjusted
by one "tooth".
The two control rods (5) must be set so that the model shows
no tendency to drift always into the same direction when
the trim sliders for nodding and rolling are at their centre
positions. In this case, the swash plate must be aligned
horizontally.
After disconnecting the ball joint sockets (6) at the swash
plate, you can adjust the rod length by twisting the joint
sockets.
For a better overview, the cockpit and left side cover were removed for the pictures in figure 18. Use a
suitable screwdriver for this and tighten the screws only with minimum application of force to neither damage
the screws nor the screw bores.
48
Figure 18