Operation Of The Model Helicopter; Commissioning Of The Model Helicopter; Charging The Flight Battery - Reely SKY Lama 6 Bedienungsanleitung


10.

Operation of the Model Helicopter

a) Charging the Flight Battery
The two-cell flight battery (1) is charged using the supplied
mains adapter (2) and the LiPo charger (3).
When charging, always remove the flight battery
from the model in order to prevent shape distortion
of the plastic parts if the components heat up.
First connect the mains adapter connection cable (4) at the
top of the LiPo charger.
The two battery charging sockets (5 and 6) are on the lower
side of the LiPo charger.
The plug of the 3-pole balancer connection cable is protected
against polarity reversal and to be connected to the left
charging socket (5).
The right charging socket (6) is intended for a 3-cell LiPo
battery with 4-pole balancer connection cable.
Attention!
When connecting the plug connector protected
against polarity reversal to the LiPo charger,
ensure that the two guide pins of the plug point
upwards.
The 2-pole connection cable with the BEC plug (7) is not
required for charging. Later on, you connect the
rechargeable battery to the model with this cable.
The connection cable of the mains adapter is wound up at delivery. Before first use, the cable retainer must
be opened and the cable unwound. The LiPo charger can charge either 2-cell LiPo batteries with 7.4 V or 3-
cell LiPo batteries with 11.1 V. Never connect a 2- and a 3-cell battery to the LiPo charger at the same time.
After connecting the mains adapter (see figure 4, item 2) to a 230 V mains socket, the green operating voltage display
at the mains adapter lights up (see figure 4, item 8) and shows that the charger is correctly supplied with voltage.
The red operating voltage display at the LiPo charger (see figure 4, item 3) lights up (see figure 4, item 9) and signals
that the charger is supplied with power.
When a battery is connected to the charger and is being charged, the green charging indicator display (see figure 4,
item 10) flashes. When charging is complete, the green charging control lamp remains lit.
Once charging is completed, disconnect the rechargeable battery from the LiPo charger and remove the
mains adapter from the mains outlet.
38
Figure 4