Reely SKY Lama 6 Bedienungsanleitung Seite 46

If the helicopter wants to drift forwards (see figure 16), reduce the speed and slide the trim slider for the roll function
(see figure 1, item 2) gradually to the back.
Push the pitch lever carefully forward and check if the adjustment was sufficient. Repeat the procedure until the model
does not show any tendency to drift forward. If the helicopter wants to drift backward, carry out a trim adjustment
forward.
The trim slider for the pitch function (see figure 1, item 12) always has to be in the bottom position for the
drive motors to be cleared.
If the control paths of the not and roll trim slider are not quite adequate for an optimum correction, you have
the possibility to change the control of the lower rotor blades mechanically. For further information, refer to
the chapter 11.
46
Figure 16