I) Trimming The Helicopter - Reely SKY Lama 6 Bedienungsanleitung

i) Trimming of the Helicopter
First start the transmitter, then the model.
Push the pitch lever (see figure 1, item 11) from the bottom position (engine off) carefully forward and observe the
response of your model. Shortly before the helicopter starts hovering, you can already determine in which direction
your model wants to move.
If the helicopter wants to turn to the right with the tip of the fuselage (see figure 14), reduce the speed and slide the trim
slider for the tail function (see figure 1, item 10) gradually to the left.
Push the pitch lever carefully forward and check if the adjustment was sufficient. Keep repeating this procedure until
the helicopter no longer has any tendency to turn to the right. If the tip of the fuselage turns to the left, carry out a right
trim adjustment.
If the helicopter wants to drift or tilt to the right (see figure 15), reduce the speed and slide the trim slider for the roll
function (see figure 1, item 4) gradually to the left.
Push the pitch lever carefully forward and check if the adjustment was sufficient. Repeat the procedure until the model
does not show any tendency to drift to the right. If the helicopter wants to drift sideways to the left, carry out a trim
adjustment to the right.
Figure 14
Figure 15
45