Operating The Transmitter; Inserting Batteries - Reely Small Pepper Drone Bedienungsanleitung

9. Operating the transmitter

The numbers used in these instructions refer to the illustration alongside the text or the illustrations within
the respective section. Cross references to other figures are indicated with the corresponding number.
a) Inserting batteries
To power the transmitter, you require 3 AAA/Micro type batteries (e.g. Conrad Item No. 652278, please order 3x).
Important:
Use only standard batteries (1.5 V/cell) and not rechargeable batteries (1.2 V/cell) as the power supply for
the transmitter.
To insert the batteries, proceed as follows:
Loosen the retaining screw (1) on the battery compart-
ment cover (2) on the back of the transmitter with a suit-
able screwdriver.
Press the latch (3) of the lid locking mechanism down and
remove the battery compartment cover.
Insert 3 AAA/Micro type batteries with correct polarity fol-
lowing the instructions on the bottom of the battery com-
partment (4). The spiral spring contact (5) must always be
connected to the negative pole of the battery.
Replace the battery compartment cover (2) again and al-
low the locking mechanism to lock into place in the trans-
mitter housing.
Re-tighten the retaining screw (1).
Figure 2
51