Herunterladen Inhalt Inhalt Diese Seite drucken

C) Binding The Transmitter With Race Copter; D) Video Transmission Channels; E) Race Timer Function - Reely X-82 RTF Bedienungsanleitung

Race copter
Vorschau ausblenden Andere Handbücher für X-82 RTF:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

c) Binding the Transmitter with Race Copter

The transmitter uses a 2.4 GHz transmission frequency and achieves a transmission range of up to approx.
60 metres, depending on the environment and ambient conditions.
• Check that the flight battery is charged. Connect the flight battery to the race copter. The Power LED (2) will start
to flash.
• Place the race copter on a flat surface.
• Set the ON/OFF switch (8) to position ON to turn on the transmitter.
• Turn the left throttle/rudder control stick (1) downwards to the lowest position.
• The race copter will beep and the Power LED (2) will constantly light up. This confirms that binding is complete and
the race copter is ready for take-off.

d) Video transmission channels

The race copter can transmit a 5.8 GHz video signal to a compatible FPV-monitor (not included). You need an FPV-
monitor for video transmission. The following table shows suitable channels with relevant DIP switch (S1 - S5) settings.
Setting
DIP switch position /
frequency
The DIP switches are situated at the bottom of the race copter below the battery compartment. DIP switch no. 6
is having no function. Follow the above table for DIP switches 1 - 5 to adjust the video transmission frequency, if
necessary. For position of DIP switches see Fig. 2.

e) Race timer function

The other DIP switch line with switches 1 - 3 are for the race timer address code setting as per table below:
DIP switch position
Channel
The race timer signal will be transmitted with an IR-signal. The transmission range is 1.5 m. The IR-emitter is situated
at the top of the race copter. See Fig. 3.
S1
S2
S3
OFF
OFF
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
OFF
ON
ON
ON
ON
ON
100
010
42385
42920
S4=ON, S5=ON
MHz
5725
5745
5765
5785
5805
5825
5845
5865
001
101
42590
42728
S4=OFF, S5=ON
MHz
5880
5860
5840
5820
5800
5780
5760
5740
111
110
44454
43025
S4=ON, S5=OFF
MHz
5866
5847
5828
5809
5790
5771
5752
5733
011
000
44361
44451
29

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis