Flying The Quadcopter; A) Pair The Transmitter With The Quadcopter; B) Ready For Take Off - Reely Ghost Bedienungsanleitung

13. Flying the Quadcopter

Important
• Please complete the steps outlined in "12. Getting ready for flight" on page 35
• Charge the quadcopter battery if you hear a beeping sound and the quadcopter
LED blinks.
• Any time you disconnect the quadcopter battery, switch the transmitter power off
then repeat the pairing process to re-establish the connection.
• Check that all parts are working correctly/no damage before flying.

a) Pair the transmitter with the quadcopter

1. Switch the transmitter ON by pressing the power button
- The LED will blink slowly while waiting to connect to the quadcopter.
- A beep will sound and the LED will be solid on when successfully paired.
2. Switch the quadcopter ON.
- Insert the battery plug into the socket on the quadcopter to switch it ON.

b) Ready for take off

1. Place the quadcopter on a horizontal surface.
- The LED will blink slowly if the surface is level.
- The LED will blink rapidly and the quadcopter will
not respond if the surface is not level.
2. Unlock the quadcopter.
- Push the throttle lever up (a short beep will sound).
- Pull the throttle lever down (a long beep will sound).
- The quadcopter LED will be solid on when unlocked.
3. Calibrate the position sensors.
- Pull both levers to the bottom right position at the same time.
- The quadcopter LED will flash briefly then light solid.
4. The quadcopter is now ready for flight.
36