Signalling Operating Modes After Switching; Cleaning; Maintenance; Troubleshooting - Ottobock C-Brace Gebrauchsanweisung

After the problem has been corrected – insofar as this is possible – 1st mode can be activated by
connecting and disconnecting the battery charger.

7.6.2 Signalling Operating Modes after Switching

Beep sig­
nal
Switched to 1st mode
Switched to 2nd mode
Switched to LOM mode
Switching process not successful.
4x
The orthosis remains in the last mode.

8 Cleaning

NOTICE
Use of unsuitable cleaning agents
> This may lead to surface damage and/or cause adhesive joints to loosen.
► Do not let the orthosis come into contact with acids or alkaline solutions, and do not treat it
with strong cleaning agents.
Clean the orthosis regularly, especially the orthosis shells. Normally, cleaning with a damp cloth
will be entirely sufficient. Ottobock Derma Clean® is recommended for disinfecting the orthosis.
Clean any plastic surfaces with water and skin-friendly soap. Removable pads, if any, can be
washed separately at a maximum temperature of 30°C / 86°F. It is important to thoroughly dry the
cleaned surfaces (not on a heater) and to make sure that no soap residue remains on the orthosis
since this could cause skin irritation.

9 Maintenance

In the interest of your own safety and in order to maintain reliability and protect the warranty, the
service inspection interval of every 12 months must be observed. This service inspection includes
an inspection of the sensors and the replacement of worn parts.
The complete orthosis with the battery charger and power supply must be sent in for the service
inspection.

9.1 Troubleshooting

After the problem has been corrected – insofar as this is possible – 1st mode can be activated by
connecting and disconnecting the battery charger.

10 Disposal

In accordance with our activities to protect the environment and also in your best interest,
Ottobock offers you the option of returning your orthosis to an Ottobock centre for disposal.
54 | Ottobock