Connecting The Battery Charger To The Orthosis - Ottobock C-Brace Gebrauchsanweisung

1) Slide the plug adapter onto the power supply until it locks into place.
2) Connect the round, three-pin plug of the power supply to the 12V receptacle on the battery
charger so that the plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the plug on the cable to the battery charger.
3) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery
charger so that the plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the plug on the cable to the battery charger.
4) Plug the power supply into a wall socket.
→ The green LED on the back of the power supply and the green LED on the battery charger
light up.
Operating States of the Power Supply and Battery Charger
Power Battery char­
supply ger LED
LED

6.2.2 Connecting the Battery Charger to the Orthosis

Indication of the charging process:
Battery charger
Cause
• Country-specific plug not fully engaged on the power supply
• Non-functional outlet
• Defective power supply
• No connection between battery charger and power supply
• Defective battery charger
Power supply and battery charger operational
1) Connect the charging plug to the charging receptacle on the
orthosis.
INFORMATION: Observe the plug direction!
→ The yellow LED on the battery charger lights up.
2) The charging process starts.
→ After approx. 6-8 hours, the orthosis battery is fully charged and
the yellow LED turns off.
3) Disconnect the orthosis when the charging process is complete.
→ This is followed by an electronics self-test which is confirmed by
beep signals. Then the orthosis switches to 1st mode.
Battery is being charged, battery capacity is less than 50%.
Battery is being charged, battery capacity is more than 50%.
Ottobock | 43