Ozone Mojo4 Betriebshandbuch Seite 15

Step 4 Group together the middle/trail-
ing edge of the wing by sorting the folds
near the B, C and D tabs.
If using a Saucisse pack go to Step 8
Step 5 Once the LE and rear of the wing
have been sorted, turn the whole wing on
its side.
Step 6 Fold the wing with 3 or 4 folds
whilst being careful to not crush the LE
Step 7 Now place the folded wing into the stuff
sack.
Step 8. If using the Saucisse Pack carefully
do it up without trapping any material.
Step 9. Turn the Saucisse on its side
and make the first fold just after the LE
reinforcements. Do not fold the plastic rein-
forcements, use 3 or 4 folds around the LE.
IMPORTANT: Do NOT lay the wing flat on the ground before
packing the glider, this will cause abrasion damage to the top
surface as you pull the glider towards the middle. ALWAYS pack
from a mushroom or lift the wing off the ground when gathering
the wing and grouping the leading edge.
Important: Do not fold the glider in the centre, you will
bend the plastics, instead pack the wing with a full concer-
tina method from tip to tip before packing into the stuff sac.
13