Securing The Child - CYBEX SOLUTION X-FIX Benutzerhandbuch

a
1
13
UNINSTALLING THE SOLUTION X-FIX
perform all installation steps in reverse order.
• Release the ISOFIX connectors (w) by simultaneously pulling and slinging
back the red release buttons (y).
• pull the seat out of the installation aids (u).
• Rotate the X-fix connectors by 180°.
• Pull the X-fix lever located at the bottom of the child car seat and push the
X-fix connectors into the child seat until completely hidden.
Note! following these steps the vehicle's seat pad will be protected and
the Isofix connectors will be prevented from being stained or damaged.
damages and stains could obstruct a smooth operation.
2

SECURING THE CHILD

place the child seat on the respective seat in the car.
• Please make sure that the backrest (a) of the child safety seat rests flat
against the backrest of the car seat so that the child seat is under no
circumstances in a sleeping position.
• When using the isofiX-anchorages in the car, make sure that the
backrest of the Solution X-fix is perfectly aligned and in full contact
with the rear vehicle seat. The position can be adjusted with the
adjustment lever (v) located on the bottom of the child car seat.
• should the headrest of the vehicle seat interfere, please pull it out
completely and turn it around or take it off entirely. The backrest (a)
optimally adjusts to almost any inclination of the vehicle seat.
Warning! The backrest of the Solution X-fix should rest flat against the
upright part of the car seat. Pushing the booster rearwards the seat should
be tightly pressed against the seat. For the best possible protection of your
child, the seat must be in a normal upright position!
Note! it is possible that some car seats that are made of soft material (e.g.
velours, leather, etc.) may show signs of usage and/or discolouration.
In order to avoid this, you could, for example, place a cover or towel
underneath it. In this context, we would also like to refer to you to our
cleaning instructions, which must absolutely be followed before the first
use of the seat.