Securing The Child - CYBEX SOLUTION B2-FIX Benutzerhandbuch

SECURING THE CHILD

1. Route the vehicle seat belt around your child and insert the belt tongue into
the belt buckle. It must lock into place with an audible "CLICK".
2. Place the lap belt in the red coloured lap belt guides (f) of the child seat.
3. Pull the shoulder belt to tighten the lap belt.
4. On the side of the car seat next to the belt buckle, the shoulder belt and the
lap belt must be inserted together in the lap belt guide (f).
5. Feed the shoulder belt through the shoulder belt guide (g) until it is inside
the belt guide.
6. Ensure that the shoulder belt runs across your child's clavicle and does not
touch your child's neck. If necessary, adjust the height of the headrest (c) to
change the position of the belt.
REMOVING AND REATTACHING THE SEAT COVER
The cover of the child seat consists of three parts (headrest, backrest and
booster). These are held in position at several places by press-studs. Once all
studs have been released, the single parts of the cover can be removed.
In order to put the covers back on the seat, follow the removal instructions in
the reverse order.
The cover may only be washed at 30 °C with a delicate wash program
��
otherwise it may result in discolouration of the cover fabric. Please wash
the cover separately from other laundry and do not dry in the dryer or in
direct sunlight!
WARRANTY AND DISPOSAL REGULATIONS
CYBEX GmbH (Riedingerstr. 18, 95448 Bayreuth, Germany) gives you 3
years warranty on this product. The warranty is valid in the country, where
this product was initially sold by a retailer to a customer. The contents of
the guarantee and all essential information required for the assertion of the
guarantee can be found on our homepage www.cybex-online.com. If a
warranty is shown in the article description, your legal rights against us for
defects remain unaffected.
Please observe the waste disposal regulations in your country.
EN
7