WIKA CPH6000 Betriebsanleitung Seite 43

7. Commissioning, operation
If the instrument is switched into "MEASURING" mode (with test item = display the
test signal as an electrical signal or as a pressure), in order to carry out a comparative
measurement or calibration without measured-value recording, then follow the
instructions on the previous page.
The following is a more detailed explanation of point "2. Preparation for
MEASURING"
a) Test item type and respective test item measuring signal [0 ... 20 mA / 4 ... 20 mA / 0 ...
1 V / 0 ... 2 V / 0 ... 5 V / 0 ... 10 V / or mechanical for dial pressure gauges]
If a comparative measurement with a mechanical gauge (test item) is being made, then
the gauge's measured value should be entered via the numeric keypad and confirmed
with the ENTER key.
b) R.-Start/Range-End:
Start of measuring range and end of measuring range of the currently to calibrate test
item
c) Unit and resolution (submenu)
d) Measurement uncertainty of the test item in % FS (i.e. of the span) or % rd (i.e. of the
measured value)
e) Measurement type for the test item (relative or absolute)
f) Test medium (pneumatic -> gas or hydraulic -> oil)
g) Voltage supply for test item (on/off) [If no external supply is required for the test
item, "OFF" should be selected to conserve energy]
XXX
Current cursor position; alter via
◁▷ ◀▶
Parameter selection from list or menu via
0.00 Parameter input via numeric keypad
Input confirmation
ENTER
WIKA operating instructions ProcessCalibrator, model CPH6000
Select and confirm (standard units) via
Customer-specific unit; with respect to bar
(input via numeric keypad)
Display resolution in operating mode
(back with )
CLEAR
Clear entry
GB
43