Quick Start - Parker 650 series Bedienungsanleitung

WWW.SDS.LTD.UK | 0117 9381800
Mount the drive vertically in a lockable cubicle.
Is the drive to operate in Local (using the keypad) or Remote Control?
If Remote Control, make Control Connections.
Make Power Connections. Power-on and follow the Quick Set-Up procedure.
Apply a small setpoint. Start and stop the motor.
Frame 1
1
3
Power
Supply
Motor
Thermistor
(link the terminals
if temperature
sensors not used)
Power Connections
Cont.4

650 Quick Start

L1
N
L1
L2
L3
+10V REF
TH1A
TH1B
Match the motor
voltage to the
M1/U
drive voltage
M2/V
M3/W Refer to the
motor nameplate
for Star/Delta
voltages
PLEASE READ THE MANUAL
Mounting Options
Cubicle
Control Options
LOCAL CONTROL (DEFAULT)
Requires Power Connections only
Control is via the Keypad
Local Setpoint
Press to apply
a small setpoint
Press to start the
motor and it will ramp
to the setpoint
Press to stop the
motor and it will ramp
to zero
REMOTE CONTROL
Requires Power Connections and
Control Connections
Control is via your control panel
See Chapter 5 to select Remote
STOP START
SPEED
0
100
Control Connections
Single Wire Starting
2-position switch
DIN1 7
Start
+24V
6
4
Speed
2
AIN1
Reference
1
0V
Chapters 3 and 4
install and run
the product
Chapter 5
details the
Keypad and
menu system
Chapter 9
holds many of the
technical details
Quick Set-Up
POWER-ON
Hold the M key until
DIAG is displayed
Navigate to the PAR menu
Press to enter the menu
and see the first parameter
Press to show the next
parameter
Press to edit the
MAX SPEED parameter
Adjust MAX SPEED
Press to exit the parameter
Press (4 times) to show P6
Press to edit the MOTOR
CURRENT parameter
Adjust MOTOR CURRENT
Refer to motor nameplate
Press to exit the parameter
Press to show P7
Press to edit the BASE
FREQUENCY parameter
Adjust BASE FREQUENCY
Press (3 times) to display
the Local Setpoint