Troubleshooting; Error Messages On The Display - Schulthess Spirit industrial wmi 220 Bedienungsanleitung

T R OU BL E S H O OT I NG
WARNING
Improper repairs can result in severe accidents, damages and operation malfunctions!
 Do not make any changes, manipulations or attempt repairs using tools such as screwdrivers, etc.

Error messages on the display

Please find below minor faults which you can rectify yourself.
PLEASE CLOSE DOOR
DOOR LOCK ERROR
CHECK WATER INLET
CHECK WATER OUTLET
UNBALANCE NO SPINNING
POWER FAILURE,
PRESS START BUTTON
POWER FAILURE,
REPEAT PROGRAMME
60
TR OUBLESHOOT ING
 Press the door until the message «PLEASE CLOSE DOOR» switches off.
 Start the wash programme.
 Acknowledge the error message by pressing the deletion button «C».
 Press the door again until you hear the lock snap shut.
 Press the start button.
The door cannot be locked despite another attempt.
 Press the «Open door» button.
 Check whether a piece of laundry is stuck in the door.
 Press the start button after you correct the malfunction.
The door lock is defect.
 Contact customer service.
 Open the water stop-valve, and press the start button..
Sieve in water supply is blocked.
 Clean the filter, see chapter «Cleaning and Maintenance/Cleaning the filters in
the water inlet».
 Press the start button after you correct the malfunction.
Interruption in water supply.
 Check whether the water drain at the installation site is clogged.
 Press the start button after you correct the malfunction.
The laundry could not be spun due to excessive unbalanced weight.
 Press the start button.
The laundry could not be spun despite pressing the start button.
 Open the door and redistribute the load.
 Start the programme again.
 Keep the programming button «A» pressed down. At the same time, press the
cursor key «Right», several times until the programme step «Spin» is displayed.
 Press the start button.
Notice
 Mix large and small pieces of laundry.
 Do not load the drum with single, heavy laundry pieces.
The washing machine was stopped due to a power outage.
The drain valve was opened.
 Press the start button to continue the programme.
 The current programme module is repeated. If necessary, add detergent.
The washing was stopped during the disinfection phase of a disinfection
programme due to a power outage.
 To ensure disinfection, start the disinfection programme again from the start
after a power outage.
 Add detergent anew.
 Press the start button