Commissioning Of The Hexacopter; Charging The Flight Battery - Reely X6 Bedienungsanleitung

10.

Commissioning of the Hexacopter

a) Charging the Flight Battery
Caution, important!
Even if this is possible easily when operating the model later, never charge the flight battery when installed.
Always remove the flight battery from the model for recharging! Place the flight battery on a fire-proof under-
ground when charging and do not charge the battery unsupervised.
The flight battery is charged with the enclosed USB charging cable. For this, the charging cable is connected
to a USB socket of a computer/notebook or to a conventional USB plug-in charger.
Charging:
Connect the flight battery (1) with the connector protected
against polarity reversal of the USB charging cable (2). Work
with the required care and do not apply any unnecessary
force.
Once the USB plug of the charger is connected to a USB so-
cket of a computer/notebook or a USB plug-in charger, char-
ging commences automatically.
When charging is completed and the rechargeable battery
charged correctly, the red charge control LED (4) in the USB
plug lights up.
Disconnect the rechargeable batteries from the charging adap-
ter right after charging and pull the USB plug from the compu-
ter/notebook or plug-in charger.
For photo-technical reasons, the USB charging cable
is illustrated in the wound-up state in figure 7. Before
first use, the cable retainer should be opened and the
cable unwound.
Practical advice
To check the charge control light in the USB plug, briefly disconnect the rechargeable battery from the charge cable
before it is fully charged. In this case, the red LED in the USB plug must light up. If you connect the rechargeable
battery again, the LED must go out.
Figure 7
45