Installing Magicsafe - Waeco MagicSafe MS660 Bedienungsanleitung

Installing MagicSafe

Workshop mode
You can set the alarm to workshop mode if, for example, the vehicle is to
be handed over for repairs or inspection (see chapter "Setting workshop
mode" on page 96). In workshop mode, all settings for the alarm system
remain stored, even if the battery is disconnected. The alarm system can
be activated and deactivated without the hand-held receiver or the elec-
tronic key.
The status LED on the key holder lights up every 15 seconds as a visual
indicator of the activation time.
6 Installing MagicSafe
NOTE
I
If you do not have sufficient technical knowledge for installing and
connecting the components in vehicles, you should have a
specialist install the alarm system in your vehicle.
6.1 Tools required (fig. 1, page 2)
For installation and assembly you will need the following tools:
Measuring ruler (4)
Centre punch (5)
Hammer (6)
Drill head set (7)
Drill (8)
Screwdriver (9)
To establish and test the electrical connection, the following tools are
required:
Diode test lamp (1) or voltmeter (2)
Hot air blower (10)
Crimping tool (11)
Soldering iron (optional) (12)
Solder (optional) (13)
66
MagicSafe MS660