Waeco MagicSafe MS660 Bedienungsanleitung Seite 90

Using MagicSafe
Example: The system PIN code is "0 1 2 3 4".
– Status LED flashes 10 x (= number 0), then switch the ignition on and
off.
– Status LED flashes 1 x (= number 1), then switch the ignition on and
off.
– Status LED flashes 2 x (= number 2), then switch the ignition on and
off.
– Status LED flashes 3 x (= number 3), then switch the ignition on and
off.
– Status LED flashes 4 x (= number 4), then switch the ignition on and
off.
The PIN code has been entered.
✓ If you have entered the PIN code correctly, the alarm system will be in
workshop mode, see chapter "Setting workshop mode" on page 96.
If you have entered the PIN code incorrectly, the alarm will start again.
In this case, repeat the procedure from the start.
NOTE
I
Please note that every time a new hand-held transmitter or wireless
radio sensors (magnetic contact switch or motion detector) are
programmed, the PIN code is changed! It is therefore vital that the
new PIN code is noted in the manual for every learning process.
10.4 Controlling the central locking with MagicSafe
Note
I
When locking using the hand-held transmitter, the ignition must be
switched on. Otherwise the alarm system will be activated as well.
If your vehicle features central locking, you can lock or unlock doors
automatically from the inside. This function has been factory-set to
deactivated. To activate it, process as follows:
➤ Program software function 11 "Locking/unlocking with ignition" to "On",
see chapter "Software functions" on page 81.
When the ignition is switched on, the central locking will now lock the vehicle
when the "Lock" button is pressed for 3 sec. The alarm system remains
deactivated.
If you switch the ignition off, all doors will be unlocked without delay.
90
MagicSafe MS660