Replacing The Batteries - Waeco MagicSafe MS660 Bedienungsanleitung

MagicSafe MS660
10.11

Replacing the batteries

Please observe the following instructions for batteries:
WARNING!
!
Keep the batteries out of reach of children.
Only use leak-proof batteries that are suitable for electronic devices.
Never attempt to do the following with batteries:
– recharge them,
– open them or
– throw them in fires.
Dispose of old batteries appropriately.
Changing the battery in the hand-held transmitter
If the hand-held transmitter's range is reduced noticeably or if the control LED
flickers during transmission, the battery needs to be replaced.
➤ Undo the screw on the bottom of the hand-held transmitter.
➤ Open the hand-held transmitter.
NOTICE!
A
Ensure the polarity of the batteries is correct when inserting. The
positive pole is at the top.
➤ Change the battery (battery type CR 2032, 3 volts).
➤ Refit the lid on the hand-held transmitter and re-insert the screw.
Changing the battery in the radio motion detector (accessory)
➤ Press the housing of the motion detector in slightly on both sides and re-
move it.
➤ Change the battery (9 volt battery).
➤ Put the housing back onto the rear wall and click it into place.
Changing the battery in the radio magnetic sensor (accessory)
➤ Take off the sensor.
➤ Undo both screws on the back of the sensor.
Using MagicSafe
97