Waeco MagicSafe MS660 Bedienungsanleitung Seite 91

MagicSafe MS660
10.5 Learning the hand-held transmitter, electronic key
and radio sensors/reading the PIN code
NOTE
I
– Learn all hand-held transmitters, electronic keys and radio
sensors (accessory) which you wish to use during the same
programming phase. This also applies for hand-held receivers
which you have used previously, or radio sensors which have
already been paired!
– Learn the hand-held transmitter and the electronic key first, then
– if applicable – the radio motion detector (accessory) and then
the radio magnetic sensors (accessory).
Proceed as follows to learn hand-held transmitters, electronic keys as well as
radio sensors (e. g. radio motion detector, radio magnetic sensors –
accessory):
Switching to learning mode
➤ Deactivate the alarm system by pressing the "Unlock" button.
➤ Open the driver's door.
➤ If you have not connected a door contact switch, you need to connect the
yellow cable belonging to MS660 to an earth point.
Maintain this connection throughout the entire programming process.
➤ Switch on the ignition.
➤ Press and hold down the "COMFORT" button.
➤ Switch the ignition off.
➤ Release the button.
✓ You are now in learning mode.
✓ The status LED flashes 10 times and then lights up continuously to
confirm.
NOTE
I
If you do not press a button within 10 seconds, you will exit the
learning mode.
Using MagicSafe
91