Waeco MagicSafe MS660 Bedienungsanleitung Seite 74

Connecting the power to MagicSafe
Black (P11)
➤ Connect this cable to earth (terminal 31).
Red (P12)
Connects the key holder to the control unit.
Yellow (P13)
NOTE
I
The boot contact switch only has to be connected if the lighting for
the passenger compartment (interior light) remains dark when the
boot is opened. In this case, use two diodes in the yellow cable as
specified in the wiring diagrams (fig. a 20, page 6).
➤ Connect this cable to the door contact switch on the driver's door and,
if required, to the boot contact switch as well.
The factory setting allows for a switch which is closed when the door is
open. If the switch is open when the door is open, this can be programmed
in the control unit, see chapter "Function 16 (Door contact/boot input)" on
page 85.
NOTE
I
If it is not possible to connect the yellow cable to the door contact
switch in your vehicle, you have to connect the yellow cable to earth
when programming new hand-held transmitters, electronic keys or
radio sensors (see chapter "Learning the hand-held transmitter,
electronic key and radio sensors/reading the PIN code" on
page 91).
Black (P14)
Connects the key holder to the control unit.
White + black (P15)
The white cable provides an additional earth-controlled output for optional
accessory modules.
The black cable is the earth cable for the ultrasonic module.
74
MagicSafe MS660