Waeco MagicSafe MS660 Bedienungsanleitung Seite 83

MagicSafe MS660
Function 4 (Convenience locking function)
This activates or deactivates the convenience locking function, see chapter
"Using the convenience locking function" on page 94.
Function 5 (Starter circuit breaker)
This function allows you to activate or deactivate the starter circuit breaker.
The starter circuit breaker is activated:
30 sec. after the ignition was switched off ("Standby" mode, see chapter
"MagicSafe operating modes" on page 65)
60 sec. after the ignition was switched off using the remote control
("Standby" mode, see chapter "MagicSafe operating modes" on page 65)
This function can only be used when function 13 is programmed to "Starter
circuit breaker".
Function 6 (Automatic reactivation)
This function reactivates the alarm system if this was deactivated by mistake
or without being noticed. This occurs when the alarm system was deactivat-
ed and no door was opened within approx. 40 sec.
Function 7 (Self-activation)
If the function is programmed to "On", the alarm system activates itself auto-
matically when the ignition is switched off, approx. 10 sec. after the last door
was closed. Deactivation remains possible using the hand-held sensor.
Function 8 (Circuit time for the convenience output)
You can choose between 20 sec. (e. g. for shutting off the dipped headlights,
Coming Home function) or 1 sec. (e. g. for opening the tailgate). This function
can only be used when function 18 is programmed to "Convenience output
on".
Function 9 (Siren/vehicle horn selection)
This function determines whether the vehicle horn or an external siren (e. g.
MS-620SI) is used. When set to "Siren", the relay switches on to constant for
30 sec. When set to "Horn", the relay switches on and off every second for
the duration of 30 sec. This function can only be used when function 13 is
programmed to "Starter circuit breaker".
Programming MagicSafe
83