Installing The Controller - Waeco MagicSafe MS660 Bedienungsanleitung

MagicSafe MS660
Insulating tape (14)
Heat shrinking sleeve
Cable bushing sleeves (optional)
To secure the cable you may require additional screws and cable binders.
6.2

Installing the controller

➤ Select a suitable installation location (fig. 6, page 4).
NOTE
I
When selecting the installation location, observe the following
instructions:
➤ Install the control unit
– in the vehicle interior
– with the main connection cable facing downwards
– under the dashboard
– not in areas where strong electrical fields could cause interference,
e. g. ignition cables or central control electronics,
– not directly next to ventilator nozzles.
➤ Where possible, use existing holes in the vehicle.
➤ Screw the control unit firmly to the vehicle with the screws supplied or use
double-sided adhesive tape.
6.3 Installing the ultrasonic module
➤ Select a suitable installation location close to the control unit.
➤ Screw the ultrasonic module firmly to the vehicle with the screws supplied
or use double-sided adhesive tape.
6.4 Installing the ultrasonic sensors
➤ Select a suitable installation location on the left and right A-pillars.
➤ Align the ultrasonic sensors with the middle of the rear window.
➤ Tightly fasten the ultrasonic sensors using the screws provided.
➤ Lay the cables down along the A pillar and over the dashboard to the
ultrasonic module.
Installing MagicSafe
67