Waeco MagicSafe MS660 Bedienungsanleitung Seite 68

Installing MagicSafe
6.5 Installing the bonnet contact switch
This switch only needs to be installed if the vehicle does not already have
one.
➤ Choose a suitable position in the engine compartment.
➤ Drill a hole with a diameter of 8 mm.
➤ During installation, make sure the distance to the closed bonnet is be-
tween 22 mm and 27 mm.
Use putty, for example, to check this distance.
You can further reduce the minimum distance by shortening the switch.
➤ Test the switch function after installation.
6.6 Installing the key holder
NOTE
I
When selecting the installation location, observe the cable lengths.
➤ Select a suitable installation location near the dashboard.
➤ Drill a hole with a diameter of 15 mm.
➤ Push the sensors into the holders until they lock into place.
6.7 Installing the alarm sirens (accessory)
Instead of the vehicle horn, you can connect an alarm siren
(e. g. item no. MS-620SI or MS-670SI).
NOTICE!
A
When installing, ensure that the installation location is not an area
where water might splash, and that it is not close to the exhaust
system.
➤ Install the alarm sirens in the interior of the vehicle.
68
MagicSafe MS660